Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-3
v1.0, July 2010
show ipv6 mroute group
This command displays the multicast configuration settings specific to IPv6 such as flags, timer
settings, incoming and outgoing interfaces, RPF neighboring routers, and expiration times of all
the entries in the multicast mroute table containing the given group IPv6 address <group-
address>.
show ipv6 mroute source
This command displays the multicast configuration settings specific to IPv6 such as flags, timer
settings, incoming and outgoing interfaces, RPF neighboring routers, and expiration times of all
the entries in the multicast mroute table containing the given source IP address or source IP
address and group IP address pair.
Outgoing
Interface List
The list of outgoing interfaces on which the packet
is forwarded.
Format show ipv6 mroute group <group-address> {detail | summary}
Modes • Privileged EXEC
• User EXEC
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Protocol The multicast routing protocol by which this entry was created.
Incoming
Interface
The interface on which the packet for this group arrives.
Outgoing
Interface List
The list of outgoing interfaces on which this packet is forwarded.
Format show ipv6 mroute source <source-address> {detail | summary}
Modes • Privileged EXEC
• User EXEC
Term Definition
To Next Page
Loading...
Need help?
General
