Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-55
v1.0, July 2010
exit-overflow-interval (OSPF)
This command configures the exit overflow interval for OSPF. It describes the number of seconds
after entering overflow state that a router will wait before attempting to leave the overflow state.
This allows the router to again originate non-default AS-external-LSAs. When set to 0, the router
will not leave overflow state until restarted. The range for seconds is 0 to 2147483647 seconds.
no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
external-lsdb-limit (OSPF)
This command configures the external LSDB limit for OSPF. If the value is -1, then there is no
limit. When the number of non-default AS-external-LSAs in a router's link-state database reaches
the external LSDB limit, the router enters overflow state. The router never holds more than the
external LSDB limit non-default AS-external-LSAs in it database. The external LSDB limit
MUST be set identically in all routers attached to the OSPF backbone and/or any regular OSPF
area. The range for limit is -1 to 2147483647.
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Default 0
Format exit-overflow-interval <seconds>
Mode Router OSPF Config
Format no exit-overflow-interval
Mode Router OSPF Config
Default -1
Format external-lsdb-limit <limit>
Mode Router OSPF Config
Format no external-lsdb-limit
Mode Router OSPF Config
To Next Page
Loading...
Need help?
General
