Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-31
v1.0, July 2010
no username snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as readwrite for the
“admin” user and readonly for all other users. The <username> value is the user name for
which the specified access mode will apply.
username snmpv3 authentication
This command specifies the authentication protocol to be used for the specified user. The valid
authentication protocols are none, md5 or sha. If you specify md5 or sha, the login password is
also used as the snmpv3 authentication password and therefore must be at least eight characters in
length. The <username> is the user name associated with the authentication protocol. You must
enter the <username> in the same case you used when you added the user. To see the case of the
<username>, enter the show users command.
no username snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to none. The
<username> is the user name for which the specified authentication protocol is used.
Format username snmpv3 accessmode <username> {readonly | readwrite}
Mode Global Config
Format no username snmpv3 accessmode <username>
Mode Global Config
Default no authentication
Format username snmpv3 authentication <username> {none | md5 | sha}
Mode Global Config
Format no username snmpv3 authentication <username>
Mode Global Config
To Next Page
Loading...
