NETGEAR GSM7228PS - Passwords Aging; Passwords History

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-35
v1.0, July 2010
passwords history
Use this command to set the number of previous passwords that shall be stored for each user
account. When a local user changes his or her password, the user will not be able to reuse any
password stored in password history. This ensures that users don’t reuse their passwords often. The
valid range is 0-10.
no passwords history
Use this command to set the password history to the default value.
passwords aging
Use this command to implement aging on passwords for local users. When a user’s password
expires, the user will be prompted to change it before logging in again. The valid range is 1-365.
The default is 0, or no aging.
no passwords aging
Use this command to set the password aging to the default value.
Default 0
Format passwords history <0-10>
Mode Global Config
Format no passwords history
Mode Global Config
Default 0
Format passwords aging <1-365>
Mode Global Config
Format no passwords aging
Mode Global Config