EasyManuals Logo

NETGEAR GSM7228PS User Manual

NETGEAR GSM7228PS
788 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #273 background imageLoading...
Page #273 background image
Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-25
v1.0, July 2010
Virtual Router Redundancy Protocol
Commands
This section describes the commands you use to view and configure Virtual Router Redundancy
Protocol (VRRP) and to view VRRP status information. VRRP helps provide failover and load
balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on
the router.
VLAN ID The identifier of the VLAN.
Logical Interface The logical unit/slot/port associated with the VLAN routing interface.
IP Address The IP address associated with this VLAN.
Subnet Mask The subnet mask that is associated with this VLAN.
Default none
Format ip vrrp
Mode Global Config
Format no ip vrrp
Mode Global Config
Term Definition

Table of Contents

Other manuals for NETGEAR GSM7228PS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GSM7228PS and is the answer not in the manual?

NETGEAR GSM7228PS Specifications

General IconGeneral
BrandNETGEAR
ModelGSM7228PS
CategorySwitch
LanguageEnglish

Related product manuals