Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-10
v1.0, July 2010
IPv6 Routing Commands
This section describes the IPv6 commands you use to configure IPv6 on the system and on the
interfaces. This section also describes IPv6 management commands and show commands.
ipv6 forwarding
This command enables IPv6 forwarding on the router.
no ipv6 forwarding
This command disables IPv6 forwarding on the router
ipv6 hop-limit
This command defines the unicast hop count used in ipv6 packets originated by the node. The
value is also included in router advertisements. Valid values for <hops> are 1-255 inclusive. The
default “not configured” means that a value of zero is sent in router advertisements and a value of
64 is sent in packets originated by the node. Note that this is not the same as configuring a value of
64.
IPv6 Prefix is The IPv6 address of the interface.
MTU size The maximum transmission size for packets on this interface, in bytes.
Default enabled
Format ipv6 forwarding
Mode Global Config
Format no ipv6 forwarding
Mode Global Config
Default not configured
Term Definition
To Next Page
Loading...
