Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-39
v1.0, July 2010
area nssa default-info-originate (OSPFv3)
This command configures the metric value and type for the default route advertised into the
NSSA. The optional metric parameter specifies the metric of the default route and is to be in a
range of 1-16777214. If no metric is specified, the default value is 10. The metric type can be
comparable (nssa-external 1) or non-comparable (nssa-external 2).
no area nssa default-info-originate (OSPFv3)
This command disables the default route advertised into the NSSA.
area nssa no-redistribute (OSPFv3)
This command configures the NSSA ABR so that learned external routes will not be redistributed
to the NSSA.
no area nssa no-redistribute (OSPFv3)
This command disables the NSSA ABR so that learned external routes are redistributed to the
NSSA.
Format area <areaid> nssa default-info-originate [<metric>] [{comparable |
non-comparable}]
Mode Router OSPFv3 Config
Format no area <areaid> nssa default-info-originate [<metric>] [{comparable
| non-comparable}]
Mode Router OSPF Config
Format area <areaid> nssa no-redistribute
Mode Router OSPFv3 Config
Format no area <areaid> nssa no-redistribute
Mode Router OSPF Config
To Next Page
Loading...
Need help?
General
