NETGEAR GSM7228PS - Show Ip Ospf Virtual-Link

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-81
v1.0, July 2010
show ip ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor.
The <areaid> parameter identifies the area and the <neighbor> parameter identifies the
neighbor's Router ID.
Metric Val The metric value is applied based on the TOS. It defaults to the least metric of the type of
service among the interfaces to other areas. The OSPF cost for a route is a function of the
metric value.
Import Summary
LSA
Controls the import of summary LSAs into stub areas.
Format show ip ospf virtual-link <areaid> <neighbor>
Modes • Privileged EXEC
• User EXEC
Term Definition
Area ID The area id of the requested OSPF area.
Neighbor Router
ID
The input neighbor Router ID.
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Iftransit Delay
Interval
The configured transit delay for the OSPF virtual interface.
Retransmit
Interval
The configured retransmit interval for the OSPF virtual interface.
Authentication
Type
The configured authentication type of the OSPF virtual interface.
State The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router. This is the state of the OSPF interface.
Neighbor State The neighbor state.
Term Definition