Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-4
v1.0, July 2010
arp purge
This command causes the specified IP address to be removed from the ARP cache. Only entries of
type dynamic or gateway are affected by this command.
arp resptime
This command configures the ARP request response timeout.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry response
timeout time in seconds. The range for <seconds> is between 1-10 seconds.
no arp resptime
This command configures the default ARP request response timeout.
arp retries
This command configures the ARP count of maximum request for retries.
The value for <retries> is an integer, which represents the maximum number of request for
retries. The range for <retries> is an integer between 0-10 retries.
Format arp purge <ipaddr>
Mode Privileged EXEC
Default 1
Format arp resptime <1-10>
Mode Global Config
Format no arp resptime
Mode Global Config
Default 4
Format arp retries <0-10>
Mode Global Config
To Next Page
Loading...
