Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-207
v1.0, July 2010
isdp holdtime
This command configures the hold time for ISDP packets that the switch transmits. The hold time
specifies how long a receiving device should store information sent in the ISDP packet before
discarding it. The range is given in seconds.
isdp timer
This command sets the period of time between sending new ISDP packets. The range is given in
seconds.
isdp advertise-v2
This command enables the sending of ISDP version 2 packets from the device.
no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
Default 180 seconds
Format isdp holdtime <10-255>
Mode Global Config
Default 30 seconds
Format isdp timer <5-254>
Mode Global Config
Default Enabled
Format isdp advertise-v2
Mode Global Config
Format no isdp advertise-v2
Mode Global Config
To Next Page
Loading...
Need help?
General
