NETGEAR GSM7228PS - Enable (Instance)

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-6
v1.0, July 2010
no configuration
Use this command to to delete a CP configuration. The default configuration cannot be deleted.
enable (Instance)
Use this command to enable a captive portal configuration.
no enable
Use this command to disable a configuration.
name
Use this command to configure the name for a captive portal configuration. The cp-name can be
up to 32 alphanumeric characters in length.
Format no configuration <1-10>
Mode Captive Portal Configuration mode
Default enable
Format enable
Mode Captive Portal Instance mode
Defaul enable
Format no enable
Mode Captive Portal Instance mode
Default Configuration 1 has the name “Default” by default. All other configurations
have no name by default.
Format name <cp-name>
Mode Captive Portal Instance mode