To Next Page

To Previous Page

Managed Switch CLI Manual, Release 8.0.3

Switching Commands 3-186

v1.0, July 2010

show lldp med interface

Use this command to display a summary of the current LLDP MED configuration for a specific

interface.

<unit/slot/port> indicates a specific physical interface. all indicates all valid

LLDP interfaces.

Example: The following shows example CLI display output for the command.

(Switch) #show lldp med interface all

Interface Link configMED operMED ConfigNotify TLVsTx

--------- ------ --------- -------- ------------ -----------

1/0/1 Down Disabled Disabled Disabled 0,1

1/0/2 Up Disabled Disabled Disabled 0,1

1/0/3 Down Disabled Disabled Disabled 0,1

1/0/4 Down Disabled Disabled Disabled 0,1

1/0/5 Down Disabled Disabled Disabled 0,1

1/0/6 Down Disabled Disabled Disabled 0,1

1/0/7 Down Disabled Disabled Disabled 0,1

1/0/8 Down Disabled Disabled Disabled 0,1

1/0/9 Down Disabled Disabled Disabled 0,1

1/0/10 Down Disabled Disabled Disabled 0,1

1/0/11 Down Disabled Disabled Disabled 0,1

1/0/12 Down Disabled Disabled Disabled 0,1

1/0/13 Down Disabled Disabled Disabled 0,1

1/0/14 Down Disabled Disabled Disabled 0,1

Format show lldp med interface {<unit/slot/port> | all}

Mode Privileged Exec

Term Definition

Interface The interface in a unit/slot/port format.

Link Shows whether the link is up or down.

ConfigMED Shows if the LLPD-MED mode is enabled or disabled on this interface

OperMED Shows if the LLPD-MED TLVs are transmitted or not on this interface.

ConfigNotify Shows if the LLPD-MED topology notification mode of this interface.

TLVsTx Shows whether the interface sends optional TLVs in the LLDPDUs. The TLV codes

can be 0 (Capabilities), 1 (Network Policy), 2 (Location), 3 (Extended PSE), 4

(Extended Pd), or 5 (Inventory).

NETGEAR GSM7228PS User Manual

Other manuals for NETGEAR GSM7228PS