Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-15
v1.0, July 2010
match dstip6
This command adds to the specified class definition a match condition based on the destination
IPv6 address of a packet.
match dstl4port
This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword or numeric notation. To specify the match
condition as a single keyword, the value for <portkey> is one of the supported port name
keywords. The currently supported <portkey> values are: domain, echo, ftp, ftpdata, http, smtp,
snmp, telnet, tftp, www. Each of these translates into its equivalent port number. To specify the
match condition using a numeric notation, one layer 4 port number is required. The port number is
an integer from 0 to 65535.
match ip dscp
This command adds to the specified class definition a match condition based on the value of the IP
DiffServ Code Point (DSCP) field in a packet, which is defined as the high-order six bits of the
Service Type octet in the IP header (the low-order two bits are not checked).
The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through one
of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be,
cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
Default none
Format match dstip6 <destination-ipv6-prefix/prefix-length>
Mode Ipv6-Class-Map Config
Default none
Format match dstl4port {<portkey> | <0-65535>}
Mode Class-Map Config
Ipv6-Class-Map Config
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to
specify a match criterion for the same Service Type field in the IP header, but with
a slightly different user notation.
To Next Page
Loading...
