NETGEAR GSM7228PS - DNS Client Commands; Ip Domain Lookup; Show Ip Dhcp Conflict

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-55
v1.0, July 2010
show ip dhcp conflict
This command displays address conflicts logged by the DHCP Server. If no IP address is specified,
all the conflicting addresses are displayed.
DNS Client Commands
These commands are used in the Domain Name System (DNS), an Internet directory service. DNS
is how domain names are translated into IP addresses. When enabled, the DNS client provides a
hostname lookup service to other components.
ip domain lookup
Use this command to enable the DNS client.
no ip domain lookup
Use this command to disable the DNS client.
Format show ip dhcp conflict [<ip-address>]
Modes • Privileged EXEC
• User EXEC
Term Definition
IP address The IP address of the host as recorded on the DHCP server.
Detection
Method
The manner in which the IP address of the hosts were found on the DHCP
Server.
Detection time The time when the conflict was found.
Default enabled
Format ip domain lookup
Mode Global Config
Format no ip domain lookup
Mode Global Config