Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-15
v1.0, July 2010
no ipv6 mtu
This command resets maximum transmission unit value to default value.
ipv6 nd dad attempts
This command sets the number of duplicate address detection probes transmitted. Duplicate
address detection verifies that an IPv6 address on an interface is unique.
no ipv6 nd dad attempts
This command resets to number of duplicate address detection value to default value.
ipv6 nd managed-config-flag
This command sets the “managed address configuration” flag in router advertisements. When the
value is true, end nodes use DHCPv6. When the value is false, end nodes automatically configure
addresses.
Default 0 or link speed (MTU value (1500))
Format ipv6 mtu <1280-1500>
Mode Interface Config
Format no ipv6 mtu
Mode Interface Config
Default 1
Format ipv6 nd dad attempts <0 - 600>
Mode Interface Config
Format no ipv6 nd dad attempts
Mode Interface Config
To Next Page
Loading...
