NETGEAR GSM7228PS - Dos-Control Tcpfinurgpsh; Dos-Control Tcpsynfin

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-200
v1.0, July 2010
dos-control tcpsynfin
This command enables TCP SYN and FIN Denial of Service protection. If the mode is enabled,
Denial of Service prevention is active for this type of attack. If packets ingress having TCP flags
SYN and FIN set, the packets will be dropped if the mode is enabled. This command is only
available on FSM72xxRS switches.
no dos-control tcpsynfin
This command sets disables TCP SYN & FIN Denial of Service protection. This command is only
available on FSM72xxRS switches.
dos-control tcpfinurgpsh
This command enables TCP FIN and URG and PSH and SEQ=0 checking Denial of Service
protections. If the mode is enabled, Denial of Service prevention is active for this type of attack. If
packets ingress having TCP FIN, URG, and PSH all set and TCP Sequence Number set to 0, the
packets will be dropped if the mode is enabled. This command is only available on FSM72xxRS
switches.
Format no dos-control tcpsyn
Mode Global Config
Default disabled
Format dos-control tcpsynfin
Mode Global Config
Format no dos-control tcpsynfin
Mode Global Config
Default disabled