Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-15
v1.0, July 2010
show ipv6 pimsm interface
This command displays interface configuration parameters for PIM-SM on the specified interface.
If no interface is specified, all interfaces are displayed.
show ipv6 pimsm neighbor
This command displays the neighbor information for PIM-SM on the specified interface.
Format show ipv6 pimsm interface [<unit/slot/port>]
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
IP Address The IPv6 address of the specified interface.
Hello Interval
(secs)
The frequency at which PIM hello messages are transmitted on this interface. By default,
the value is 30 seconds.
Join Prune
Interval (secs)
The join/prune interval for the PIM-SM router. The interval is in seconds.
Neighbor Count The neighbor count for the PIM-SM interface.
Designated
Router
The IP address of the Designated Router for this interface.
DR Priority The priority of the Designated Router.
BSR Border The bootstrap router border interface. Possible values are enabled or disabled.
Format show ipv6 pimsm neighbor {<unit/slot/port> | all}
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
IP Address The IPv6 address of the neighbor on an interface.
Up Time The time since this neighbor has become active on this interface.
Expiry Time The expiry time of the neighbor on this interface.
To Next Page
Loading...
