Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-58
v1.0, July 2010
radius server retransmit
This command configures the global parameter for the RADIUS client that specifies the number of
transmissions of the messages to be made before attempting the fall back server upon unsuccessful
communication with the current RADIUS authenticating server. When the maximum number of
retries are exhausted for the RADIUS accounting server and no response is received, the client
does not communicate with any other server.
no radius server retransmit
The no version of this command sets the value of this global parameter to the default value.
radius server timeout
This command configures the global parameter for the RADIUS client that specifies the timeout
value (in seconds) after which a request must be retransmitted to the RADIUS server if no
response is received. The timeout value is an integer in the range of 1 to 30.
Field Description
ip addr The IP address of the RADIUS Authenticating server.
dnsname The DNS name of the server.
Default 4
Format radius server retransmit <retries>
Mode Global Config
Field Description
retries The maximum number of transmission attempts in the range of 1 to 15.
Format no radius server retransmit
Mode Global Config
To Next Page
Loading...
