Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-123
v1.0, July 2010
ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come. The default
rate is 15 pps with a range from 0 to 30 pps. The default burst level is 1 second with a range of 1 to
15 seconds.
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the burst level,
to the defaults.
Format no ip dhcp snooping binding <mac-address>
Mode Global Config
Format ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode Global Config
Format no ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode Global Config
Default 15 pps for rate limiting and 1 sec for burst interval
Format ip dhcp snooping limit {rate pps [burst interval seconds]}
Mode Interface Config
To Next Page
Loading...
