NETGEAR GSM7228PS - Distance Ospf (Ospf); Distribute-List out (Ospf)

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-54
v1.0, July 2010
distance ospf (OSPF)
This command sets the route preference value of OSPF in the router. Lower route preference
values are preferred when determining the best route. The type of OSPF route can be intra,
inter, or external. All the external type routes are given the same preference value. The
range of <preference> value is 1 to 255.
no distance ospf
This command sets the default route preference value of OSPF routes in the router. The type of
OSPF can be intra, inter, or external. All the external type routes are given the same preference
value.
distribute-list out (OSPF)
Use this command to specify the access list to filter routes received from the source protocol.
no distribute-list out
Use this command to specify the access list to filter routes received from the source protocol.
Default 110
Format distance ospf {intra-area <1-255> | inter-area <1-255> | external <1-
255>}
Mode Router OSPF Config
Format no distance ospf {intra-area | inter-area | external}
Mode Router OSPF Config
Format distribute-list <1-199> out {rip | static | connected}
Mode Router OSPF Config
Format no distribute-list <1-199> out {rip | static | connected}
Mode Router OSPF Config