NETGEAR GSM7228PS - Show Trapflags

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-51
v1.0, July 2010
The following shows an example of the CLI command.
(Netgear Switch)#show snmptrap
Community Name IpAddress IPv6 Address Snmp Version Mode
Mytrap 0.0.0.0 2001::1 SNMPv2 Enable show trapflags
show trapflags
This command displays trap conditions. The command’s display shows all the enabled OSPFv2
and OSPFv3 trapflags. Configure which traps the switch should generate by enabling or disabling
the trap condition. If a trap condition is enabled and the condition is detected, the SNMP agent on
the switch sends the trap to all enabled trap receivers. You do not have to reset the switch to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Term Definition
SNMP Trap
Name
The community string of the SNMP trap packet sent to the trap manager. The string is
case sensitive and can be up to 16 alphanumeric characters.
IP Address The IPv4 address to receive SNMP traps from this device.
IPv6 Address The IPv6 address to receive SNMP traps from this device.
SNMP Version SNMPv2
Status The receiver's status (enabled or disabled).
Format show trapflags
Mode Privileged EXEC
Term Definition
Authentication
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether
authentication failure traps will be sent.
Link Up/Down
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether link status
traps will be sent.
Multiple Users
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will
be sent when the same user ID is logged into the switch more than once at the same time
(either through Telnet or the serial port).
Spanning Tree
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether spanning
tree traps are sent.
ACL Traps May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps
are sent.