NETGEAR GSM7228PS - Session-Timeout (Captive Portal)

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-12
v1.0, July 2010
session-timeout (Captive Portal)
Use this command to configure the session timeout for a captive portal configuration.
After this limit has been reached, the user will be disconnected. Timeout is time in
seconds.
0 indicates timeout not enforced.
no session-timeout
Use this command to reset the session timeout to the default.
idle-timeout
Use this command to configure the idle timeout for a captive portal configuration. 0
indicates timeout not enforced.
After an idle session has been reached this, the user will be
disconnected
.
no idle-timeout
Use this command to reset the idle timeout to the default.
Format max-total-octets <0-4294967295>
Mode Captive Portal Instance mode
Default 0
Format session-timeout <0-86400>
Mode Captive Portal Instance mode
Format session-timeout <0-86400>
Mode Captive Portal Instance mode
Default 0
Format idle-timeout <0-900>
Mode Captive Portal Instance mode