Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-20
v1.0, July 2010
If you specify 0 (defined as the default CIST ID) as the <mstid>, this command sets the Bridge
Priority parameter to a new value for the common and internal spanning tree. The bridge priority
value is a number within a range of 0 to 61440. The twelve least significant bits are masked
according to the 802.1s specification. This causes the priority to be rounded down to the next
lower valid priority.
no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance to the default
value. The parameter <mstid> is a number that corresponds to the desired existing multiple
spanning tree instance.
If 0 (defined as the default CIST ID) is passed as the <mstid>, this command sets the Bridge
Priority parameter for the common and internal spanning tree to the default value.
spanning-tree mst vlan
This command adds an association between a multiple spanning tree instance and one or more
VLANs so that the VLAN(s) are no longer associated with the common and internal spanning tree.
The parameter <mstid> is a number that corresponds to the desired existing multiple spanning
tree instance. The vlan range can be specified as a list or as a range of values. To specify a list of
VLANs, enter a list of VLAN IDs, each separated by a comma with no spaces in between. To
specify a range of VLANs, separate the beginning and ending VLAN ID with a dash ("-").
Default 32768
Format spanning-tree mst priority
<mstid> <0-61440>
Mode Global Config
Format no spanning-tree mst priority
<mstid>
Mode Global Config
Format spanning-tree mst vlan <mstid> <vlanid>
Mode Global Config
To Next Page
Loading...
