NETGEAR GSM7228PS - Speed All

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-7
v1.0, July 2010
no shutdown all
This command enables all ports.
speed
This command sets the speed and duplex setting for the interface.
speed all
This command sets the speed and duplex setting for all interfaces.
Format no shutdown all
Mode Global Config
Format speed {<100 | 10> <half-duplex | full-duplex>}
Mode Interface Config
Acceptable
Values
Definition
100h 100BASE-T half duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex
Format speed all {<100 | 10> <half-duplex | full-duplex>}
Mode Global Config
Acceptable
Values
Definition
100h 100BASE-T half duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex