NETGEAR GSM7228PS - Show Ipv6 Mld-Proxy Interface

Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-25
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 mld-proxy
Interface Index............................................. 1/0/3
Admin Mode................................................ Enable
Operational Mode......................................... Enable
Version......................................................... 3
Num of Multicast Groups............................. 0
Unsolicited Report Interval.......................... 1
Querier IP Address on Proxy Interface........ fe80::1:2:5
Older Version 1 Querier Timeout................ 00:00:00
Proxy Start Frequency.................................
show ipv6 mld-proxy interface
This command displays a detailed list of the host interface status parameters. It displays the
following parameters only when you enable MLD-Proxy.
Field Description
Interface Index The interface number of the MLD-Proxy.
Admin Mode Indicates whether MLD-Proxy is enabled or disabled. This is a configured
value.
Operational Mode Indicates whether MLD-Proxy is operationally enabled or disabled. This is a
status parameter.
Version The present MLD host version that is operational on the proxy interface.
Number of Multicast Groups The number of multicast groups that are associated with the MLD-Proxy
interface.
Unsolicited Report Interval The time interval at which the MLD-Proxy interface sends unsolicited group
membership report.
Querier IP Address on Proxy
Interface
The IP address of the Querier, if any, in the network attached to the upstream
interface (MLD-Proxy interface).
Older Version 1 Querier
Timeout
The interval used to timeout the older version 1 queriers.
Proxy Start Frequency The number of times the MLD-Proxy has been stopped and started.
Format show ipv6 mld-proxy interface
Modes • Privileged EXEC
• User EXEC