Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-103
v1.0, July 2010
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Partner’s System ID.
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the static
mode for a new port-channel is disabled, which means the port-channel is dynamic. However if the
maximum number of allowable dynamic port-channels are already present in the system, the static
mode for a new port-channel enabled, which means the port-channel is static.You can only use this
command on port-channel interfaces.
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
Note: This command is only applicable to physical interfaces.
Format no lacp partner system priority
Mode Interface Config
Default disabled
Format port-channel static
Mode Interface Config
Format no port-channel static
Mode Interface Config
To Next Page
Loading...
