Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-132
v1.0, July 2010
ip arp inspection validate
Use this command to enable additional validation checks like source-mac validation, destination-
mac validation, and ip address validation on the received ARP packets. Each command overrides
the configuration of the previous command. For example, if a command enables src-mac and dst-
mac validations, and a second command enables IP validation only, the src-mac and dst-mac
validations are disabled as a result of the second command.
no ip arp inspection validate
Use this command to disable the additional validation checks on the received ARP packets.
ip arp inspection vlan logging
Use this command to enable logging of invalid ARP packets on a list of comma-separated VLAN
ranges.
Format no ip arp inspection vlan vlan-list
Mode Global Config
Default disabled
Format ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode Global Config
Format no ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode Global Config
Default enabled
Format ip arp inspection vlan vlan-list logging
Mode Global Config
To Next Page
Loading...
Need help?
General
