NETGEAR GSM7228PS - O;S Support

Managed Switch CLI Manual, Release 8.0.3
Log Messages 11-26
v1.0, July 2010
O/S Support
OS USL: failed to sync initiator table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync terminator table on
unit=x
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync ip-multicast table on
unit=x
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Table 11-53: OSAPI Log Messages
Component Message Cause
OSAPI ftruncate failed – File resides on a read-only
file system.
ftruncate is called to correctly set the file’s
size in the file system after a write. The file
system is R/W so this msg indicates the file
system may be corrupted.
OSAPI ftruncate failed – File is open for reading
only.
ftruncate is called to correctly set the file’s
size in the file system after a write. The file is
opened for R/W so this msg indicates the file
system may be corrupted.
OSAPI ftruncate failed – File descriptor refers to a
file on which this operation is impossible.
ftruncate is called to correctly set the file’s
size in the file system after a write. This msg
indicates the file system may be corrupted.
OSAPI ftruncate failed – Returned an unknown
code in errno.
ftruncate is called to correctly set the file’s
size in the file system after a write. This msg
indicates the file system may be corrupted.
OSAPI ping: bad host! The address requested to ping can not be
converted to an Internet address.
OSAPI osapiTaskDelete: Failed for (XX) error YYY The requested task can not be deleted
because: the requested deletion is called
from an ISR, the task is already deleted, or
the task ID is invalid.
Table 11-52: System General Error Messages
Component Message Cause