Managed Switch CLI Manual, Release 8.0.3
Log Messages 11-25
v1.0, July 2010
OS USL: A Trunk being set doesn't exist in USL Possible synchronization issue between the
application, hardware, and sync layer.
OS USL: failed to sync trunk table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: Mcast entry not found on a join Possible synchronization issue between the
application, hardware, and sync layer
OS USL: Mcast entry not found on a leave Possible synchronization issue between the
application, hardware, and sync layer
OS USL: failed to sync dvlan data on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync policy table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync VLAN table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS Invalid LAG id x Possible synchronization issue between the
BCM driver and HAPI
OS Invalid uport calculated from the BCM uport
bcmx_l2_addr->lport = x
Uport not valid from BCM driver.
OS Invalid USP calculated from the BCM
uport\nbcmx_l2_addr->lport = x
USP not able to be calculated from the learn
event for BCM driver.
OS Unable to insert route R/P Route ‘R’ with prefix ‘P’ could not be inserted
in the hardware route table. A retry will be
issued.
OS Unable to Insert host H Host ‘H’ could not be inserted in hardware
host table. A retry will be issued.
OS USL: failed to sync L3 Intf table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync L3 Host table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: failed to sync L3 Route table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Table 11-52: System General Error Messages
Component Message Cause
To Next Page
Loading...
