NETGEAR GSM7228PS - Show Interface Loopback

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-9
v1.0, July 2010
no interface loopback
This command removes the loopback interface and associated configuration parameters for the
specified loopback interface.
show interface loopback
This command displays information about configured loopback interfaces.
If you do not specify a loopback ID, the following information appears for each loopback interface
on the system:
If you specify a loopback ID, the following information appears:
Format no interface loopback <loopback-id>
Mode Global Config
Format show interface loopback [<loopback-id>]
Mode Privileged EXEC
Term Definition
Loopback ID The loopback ID associated with the rest of the information in the row.
Interface The interface name.
IP Address The IPv4 address of the interface.
Received
Packets
The number of packets received on this interface.
Sent Packets The number of packets transmitted from this interface.
IPv6 Address The IPv6 address of this interface.
Term Definition
Interface Link
Status
Shows whether the link is up or down.
IP Address The IPv4 address of the interface.
IPv6 is enabled
(disabled)
Shows whether IPv6 is enabled on the interface.