Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-21
v1.0, July 2010
ip irdp address
This command configures the address that the interface uses to send the router discovery
advertisements. The valid values for <ipaddr> are 224.0.0.1, which is the all-hosts IP multicast
address, and 255.255.255.255, which is the limited broadcast address.
no ip irdp address
This command configures the default address used to advertise the router for the interface.
ip irdp holdtime
This command configures the value, in seconds, of the holdtime field of the router advertisement
sent from this interface. The holdtime range is the value of <maxadvertinterval> to 9000
seconds.
no ip irdp holdtime
This command configures the default value, in seconds, of the holdtime field of the router
advertisement sent from this interface.
Default 224.0.0.1
Format ip irdp address <ipaddr>
Mode Interface Config
Format no ip irdp address
Mode Interface Config
Default 3 * maxinterval
Format ip irdp holdtime <maxadvertinterval-9000>
Mode Interface Config
Format no ip irdp holdtime
Mode Interface Config
To Next Page
Loading...
