Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-12
v1.0, July 2010
ipv6 pimsm rp-candidate
This command is used to configure the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
no ipv6 pimsm rp-candidate
This command is used to disable the router to advertise itself as a PIM candidate rendezvous point
(RP) to the bootstrap router (BSR).
ipv6 pimsm spt-threshold
This command is used to configure the Data Threshold rate for the last-hop router to switch to the
shortest path. The rate is specified in Kilobits per second. The possible values are 0 to 2000.
no ipv6 pimsm spt-threshold
This command is used to set the Data Threshold rate for the RP router to the default value.
Default None
Format ipv6 pimsm rp-candidate interface <unit/slot/port> <group-address>
<group-mask>
Mode Global Config
Format no ipv6 pimsm rp-candidate interface <unit/slot/port> <group-address>
<group-mask>
Mode Global Config
Default 0
Format ipv6 pimsm spt-threshold <1-2000>
Mode Global Config
Format no ipv6 pimsm spt-threshold
Mode Global Config
To Next Page
Loading...
