Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-39
v1.0, July 2010
no protocol group
This command removes the <vlanid> from this protocol-based VLAN group that is identified
by this <groupid>.
protocol vlan group
This command adds the physical interface to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate each
interface and protocol combination with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command fails and the
interface(s) are not added to the group.
no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is identified by
this <groupid>.
Default none
Format protocol group <groupid> <vlanid>
Mode VLAN Config
Format no protocol group <groupid> <vlanid>
Mode VLAN Config
Default none
Format protocol vlan group <groupid>
Mode Interface Config
Format no protocol vlan group <groupid>
Mode Interface Config
To Next Page
Loading...
