Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-73
v1.0, July 2010
script show
This command displays the contents of a script file, which is named <scriptname>.
script validate
This command validates a script file by parsing each line in the script file where <scriptname>
is the name of the script to validate.The validate option is intended to be used as a tool for script
development. Validation identifies potential problems. It might not identify all problems with a
given script on any given device.
Pre-login Banner and System Prompt Commands
This section describes the commands you use to configure the pre-login banner and the system
prompt. The pre-login banner is the text that displays before you login at the User: prompt.
copy (pre-login banner)
The copy command includes the option to upload or download the CLI Banner to or from the
switch. You can specify local URLs by using TFTP, Xmodem, Ymodem, or Zmodem.
Format script show <scriptname>
Mode Privileged EXEC
Term Definition
Output Format line
<number>: <line contents>
Format script validate
<scriptname>
Mode Privileged EXEC
Note: <ip6address> is also a valid parameter for routing packages that support IPv6.
To Next Page
Loading...
