Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-26
v1.0, July 2010
Example: The following are examples of the CLI command.
traceroute Success:
(Switch) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count
3 port 33434 size 43
Traceroute to 10.240.10.115 ,4 hops max 43 byte packets:
1 10.240.4.1 708 msec 41 msec 11 msec
2 10.240.10.115 0 msec 0 msec 0 msec
Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6
traceroute Failure:
(Switch) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3
port 33434 size 43
Traceroute to 10.40.1.1 ,30 hops max 43 byte packets:
1 10.240.4.1 19 msec 18 msec 9 msec
2 10.240.1.252 0 msec 0 msec 1 msec
3 172.31.0.9 277 msec 276 msec 277 msec
4 10.254.1.1 289 msec 327 msec 282 msec
5 10.254.21.2 287 msec 293 msec 296 msec
6 192.168.76.2 290 msec 291 msec 289 msec
7 0.0.0.0 0 msec *
Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18
traceroute ipv6
Use the traceroute command to discover the routes that packets actually take when traveling
to their destination through the network on a hop-by-hop basis. The <ipv6-
address|hostname> parameter must be a valid IPv6 address or hostname. The optional
<port> parameter is the UDP port used as the destination of packets sent as part of the
traceroute. This port should be an unused port on the destination system. The range for <port>
is zero (0) to 65535. The default value is 33434.
Default port: 33434
Format traceroute ipv6 <ipv6-address|hostname> [port <port>]
Mode Privileged EXEC
To Next Page
Loading...
