NETGEAR GSM7228PS - Sntp Unicast Client Poll-Interval; Sntp Unicast Client Poll-Retry; Sntp Unicast Client Poll-Timeout

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-36
v1.0, July 2010
sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of two where
<poll-interval> can be a value from 6 to 10.
no sntp unicast client poll-interval
This command resets the poll interval for SNTP unicast clients to its default value.
sntp unicast client poll-timeout
This command will set the poll timeout for SNTP unicast clients in seconds to a value from 1-30.
no sntp unicast client poll-timeout
This command will reset the poll timeout for SNTP unicast clients to its default value.
sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients to a value from 0 to 10.
Default 6
Format sntp unicast client poll-interval <poll-interval>
Mode Global Config
Format no sntp unicast client poll-interval
Mode Global Config
Default 5
Format sntp unicast client poll-timeout <poll-timeout>
Mode Global Config
Format no sntp unicast client poll-timeout
Mode Global Config
Default 1