Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-62
v1.0, July 2010
passive-interface default (OSPF)
Use this command to enable global passive mode by default for all interfaces. It overrides any
interface level passive mode. OSPF will not form adjacencies over a passive interface.
no passive-interface default
Use this command to disable the global passive mode by default for all interfaces. Any interface
previously configured to be passive reverts to non-passive mode.
passive-interface (OSPF)
Use this command to set the interface or tunnel as passive. It overrides the global passive mode
that is currently effective on the interface or tunnel.
no passive-interface
Use this command to set the interface or tunnel as non-passive. It overrides the global passive
mode that is currently effective on the interface or tunnel.
Default disabled
Format passive-interface default
Mode Router OSPF Config
Format no passive-interface default
Mode Router OSPF Config
Default disabled
Format passive-interface {<unit/slot/port>}
Mode Router OSPF Config
Format no passive-interface {<unit/slot/port>}
Mode Router OSPF Config
To Next Page
Loading...
