Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-31
v1.0, July 2010
show ip igmp
This command displays the system-wide IGMP information.
show ip igmp groups
This command displays the registered multicast groups on the interface. If [detail] is specified
this command displays the registered multicast groups on the interface in detail.
If you do not use the detail keyword, the following fields appear:
The following fields are not displayed if the interface is not enabled:
Format show ip igmp
Modes • Privileged EXEC
• User EXEC
Term Definition
IGMP Admin
Mode
The administrative status of IGMP. This is a configured value.
Interface Valid unit, slot, and port number separated by forward slashes.
Interface-Mode Indicates whether IGMP is enabled or disabled on the interface. This is a configured
value.
Opeational-
Status
The current state of IGMP on this interface. Possible values are Operational or Non-
Operational.
Format show ip igmp groups <unit/slot/port> [detail]
Mode Privileged EXEC
Term Definition
IP Address The IP address of the interface participating in the multicast group.
Subnet Mask The subnet mask of the interface participating in the multicast group.
Interface Mode This displays whether IGMP is enabled or disabled on this interface.
Term Definition
Querier Status This displays whether the interface has IGMP in Querier mode or Non-Querier mode.
Groups The list of multicast groups that are registered on this interface.
To Next Page
Loading...
Need help?
General
