Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-53
v1.0, July 2010
default-information originate (OSPF)
This command is used to control the advertisement of default routes.
no default-information originate (OSPF)
This command is used to control the advertisement of default routes.
default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
no default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Default • metric—unspecified
• type—2
Format default-information originate [always] [metric <0-16777214>] [metric-
type {1 | 2}]
Mode Router OSPF Config
Format no default-information originate [metric] [metric-type]
Mode Router OSPF Config
Format default-metric <1-16777214>
Mode Router OSPF Config
Format no default-metric
Mode Router OSPF Config
To Next Page
Loading...
