Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-10
v1.0, July 2010
The following field is displayed only when DVMRP is operational on the interface.
The following fields are displayed only if DVMRP is enabled on this interface.
show ip dvmrp neighbor
This command displays the neighbor information for DVMRP.
Term Definition
Generation ID The Generation ID value for the interface. This is used by the neighboring routers to
detect that the DVMRP table should be resent.
Term Definition
Received Bad
Packets
The number of invalid packets received.
Received Bad
Routes
The number of invalid routes received.
Sent Routes The number of routes that have been sent on this interface.
Format show ip dvmrp neighbor
Modes • Privileged EXEC
• User EXEC
Term Definition
IfIndex The value of the interface used to reach the neighbor.
Nbr IP Addr The IP address of the DVMRP neighbor for which this entry contains information.
State The state of the neighboring router. The possible value for this field are ACTIVE or
DOWN.
Up Time The time since this neighboring router was learned.
Expiry Time The time remaining for the neighbor to age out. This field is not applicable if the State is
DOWN.
Generation ID The Generation ID value for the neighbor.
Major Version The major version of DVMRP protocol of neighbor.
Minor Version The minor version of DVMRP protocol of neighbor.
Capabilities The capabilities of neighbor.
Received Routes The number of routes received from the neighbor.
Rcvd Bad Pkts The number of invalid packets received from this neighbor.
To Next Page
Loading...
