Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-30
v1.0, July 2010
no usermane
This command removes a user account.
username nopassword
This command removes the password from a user.
username <username> unlock
Use this command to unlock a locked user account. Only a user with read/write access can re-
activate a locked user account.
username snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are readonly or readwrite. The <username> is the login user name
for which the specified access mode applies. The default is readwrite for the “admin” user and
readonly for all other users. You must enter the <username> in the same case you used when
you added the user. To see the case of the <username>, enter the show users command.
Format no username <username>
Mode Global Config
Note: You cannot delete the “admin” user account.
Format username <name> nopassword [level level]
Mode Global Config
Format username <username> unlock
Mode Global Config
Defaults • admin - readwrite
• other - readonly
To Next Page
Loading...
