Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-49
v1.0, July 2010
no snmp trap link-status
This command disables link status traps by interface.
snmp trap link-status all
This command enables link status traps for all interfaces.
no snmp trap link-status all
This command disables link status traps for all interfaces.
Format snmp trap link-status
Mode Interface Config
Note: This command is valid only when the Link Up/Down Flag is enabled.
Format no snmp trap link-status
Mode Interface Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-
server enable traps linkmode” on page 10-45
Format snmp trap link-status all
Mode Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-
server enable traps linkmode” on page 10-45
Format no snmp trap link-status all
Mode Global Config
To Next Page
Loading...
