Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-210
v1.0, July 2010
show isdp entry
This command displays ISDP entries. If the device id is specified, then only entries for that device
are shown.
show isdp neighbors
This command displays the list of neighboring devices.
Format show isdp entry {all | deviceid}
Mode Privileged EXEC
Term Definition
Device ID The device ID associated with the neighbor which advertised the information.
IP Addresses The IP address(es) associated with the neighbor.
Platform The hardware platform advertised by the neighbor.
Interface The interface (slot/port) on which the neighbor's advertisement was received.
Port ID The port ID of the interface from which the neighbor sent the advertisement.
Hold Time The hold time advertised by the neighbor.
Version The software version that the neighbor is running.
Advertisement
Version
The version of the advertisement packet received from the neighbor.
Capability ISDP Functional Capabilities advertised by the neighbor.
Format show isdp neighbors [ {<unit/slot/port> | detail} ]
Mode Privileged EXEC
Term Definition
Device ID The device ID associated with the neighbor which advertised the information.
IP Addresses The IP addresses associated with the neighbor.
Capability ISDP functional capabilities advertised by the neighbor.
Platform The hardware platform advertised by the neighbor.
Interface The interface (unit/slot/port) on which the neighbor's advertisement was received.
To Next Page
Loading...
