Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-96
v1.0, July 2010
no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
lacp actor admin state passive
Use this command to set the LACP actor admin state to passive.
no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
Format no lacp actor admin state longtimeout
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format lacp actor admin state passive
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp actor admin state passive
Mode Interface Config
To Next Page
Loading...
