NETGEAR GSM7228PS - Ipv6 PIM-DM Commands

Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-4
v1.0, July 2010
If you use the detail parameter, the command displays the following column headings in the
output table:
If you use the summary parameter, the command displays the following column headings in the
output table:
IPv6 PIM-DM Commands
This section describes the Protocol Independent Multicast -Dense Mode (PIM-DM) commands to
support the PIM version of IPv6.
ipv6 pimdm
Use this command to administratively enable PIM-DM Multicast Routing Mode either across the
router (Global Config) or on a particular router (Interface Config).
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Expiry Time The time of expiry of this entry in seconds.
Up Time The time elapsed since the entry was created in seconds.
RPF Neighbor The IP address of the RPF neighbor.
Flags The flags associated with this entry.
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Protocol The multicast routing protocol by which this entry was created.
Incoming
Interface
The interface on which the packet for this source arrives.
Outgoing
Interface List
The list of outgoing interfaces on which this packet is forwarded.