NETGEAR GSM7228PS - Login Authentication; Serial Timeout

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-9
v1.0, July 2010
no serial baudrate
This command sets the communication rate of the terminal interface.
serial timeout
This command specifies the maximum connect time (in minutes) without console activity. A value
of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
no serial timeout
This command sets the maximum connect time (in minutes) without console activity.
login authentication
To specify login authentication method list for remote telnet or console, use the
login
authentication command in line configuration mode.
no login authentication
To return to the default specified by the
login authentication command.
Format no serial baudrate
Mode Line Config
Default 5
Format serial timeout <0-160>
Mode Line Config
Format no serial timeout
Mode Line Config
Format login authentication {default | list-name}
Mode Line Config
Format no login authentication {default | list-name}
Mode Line Config