Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-14
v1.0, July 2010
block
Use this command to block all traffic for a captive portal configuration. The administrator can
block access to a captive portal configuration. When an instance is blocked no client traffic is
allowed through any interfaces associated with that captive portal configuration. Blocking a
captive portal instance is a temporary command executed by the administrator and not saved in the
configuration.
no block
Use this command to unblock traffic.
Captive Portal Status Commands
This section describes commands that return captive portal status.
show captive-portal configuration
Use this command to display the operational status of each captive portal configuration.
Format no interface <unit/slot/port>
Mode Captive Portal Instance Config mode
Default no block
Format block
Mode Captive Portal Instance mode
Format no block
Mode Captive Portal Instance mode
To Next Page
Loading...
