NETGEAR GSM7228PS - Enable Password

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-29
v1.0, July 2010
enable password
This command prompts you to change the Privileged EXEC password. Passwords are a maximum
of 64 alphanumeric characters. The password is case sensitive. The option [encrypted] allows the
administrator to transfer the enable password between devices without having to know the
password. In this case, the <password> parameter must be exactly 128 hexadecimal characters..
logout
This command closes the current telnet connection or resets the current serial connection.
ping
Use this command to determine whether another computer is on the network. Ping provides a
synchronous response when initiated from the CLI and Web interfaces.
Format enable password <passwor> [encrypted]
Mode Privileged EXEC
Note: Save configuration changes before logging out.
Format logout
Modes • Privileged EXEC
• User EXEC
Default • The default count is 1.
• The default interval is 3 seconds.
• The default size is 0 bytes.
Format ping <ipaddress|hostname> [count <count>] [interval <interval>] [size
<size>]
Modes • Privileged EXEC
• User EXEC