NETGEAR GSM7228PS - User Idle-Timeout; User Session-Timeout

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-26
v1.0, July 2010
no user group
Use this command to dis-associate a group and user.
user session-timeout
Use this command to set the session timeout value for a captive portal user. Use the “no” form of
this command to reset the session timeout to the default. The range of session timeout is 0-86400.
0 indicates use global configuration.
t
no user session-timeout
Use this command to reset the session timeout to the default.
user idle-timeout
Use this command to set the session idle timeout value for a captive portal user. <1-128> is
the user ID. The range of idle timeout is 0-900 seconds. 0 indicates use global configuration.
Format no user <1-128> group <1-10>
Mode Captive Portal Configuration mode
Defaul 0
Format user <1-128> session-timeout timeout
Mode Captive Portal Configuration mode
Format no user <1-128> session-timeout
Mode Captive Portal Configuration mode
Default 0
Format user <1-128> idle-timeout timeout
Mode Captive Portal Configuration mode