NETGEAR GSM7228PS - Clear Config; Clear Counters; Clear Logging Buffered; Clear Mac-Addr-Table

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-27
v1.0, July 2010
clear config
This command resets the configuration to the factory defaults without powering off the switch.
When you issue this command, a prompt appears to confirm that the reset should proceed. When
you enter y, you automatically reset the current configuration on the switch to the default values. It
does not reset the switch.
clear mac-addr-table
This command clears the dynamically learned MAC addresses of the switch.
clear logging buffered
This command clears the messages maintained in the system log.
clear counters
This command clears the statistics for a specified <unit/slot/port>, for all the ports, or for
the entire switch based upon the argument.
Format clear config
Mode Privileged EXEC
Format clear mac-addr-table
Mode Privileged EXEC
Format clear logging buffered
Mode Privileged EXEC
Format clear counters {<unit/slot/port> | all}
Mode Privileged EXEC